Tweet
So I am starting to re-wire the AEM UEGO Wideband and im pretty positive that the wires they give you are not long enough to read the sensor, unless im planning to route the wires in the wrong direction... where did you guys send it through? or should i be cutting and extending? or did you buy and extension?
-
Wait, Is that a V6 or V8?
1990 Chevrolet C-K 1500 series 4.3L .. 5spd
1994 JDM Euno Roadster 1.8L 5spd Bolt Ons.. etc
2000 Camaro 3.8L Auto Bolt Ons..etc
-
Re: installing AEM UEGO Wideband Questions!
You can always put a hole on the passenger side floorpan and run it from there, just make sure you put a grommet or some kind of barrier in there to keep the inside of the car dry. Where were you trying to route the wires?1995 Pontiac Firebird
2008 Chevrolet Silverado LT Crew Cab 4x4 -
Re: installing AEM UEGO Wideband Questions!
Mine is run from my middle vent, through the engine bay and down to my downpipe and I still had to coil some of the wire.Comment
-
Re: installing AEM UEGO Wideband Questions!
Initially I was thinking where the sub woofer wiring is (passenger side by the feet) I don't know why lol, making a hole seems easier.. Just that the connector ends are both fairly wide. I like the floor pan idea, just sounds kinda bad putting holes in it lol
And which middle vent, like on the dash?Wait, Is that a V6 or V8?
1990 Chevrolet C-K 1500 series 4.3L .. 5spd
1994 JDM Euno Roadster 1.8L 5spd Bolt Ons.. etc
2000 Camaro 3.8L Auto Bolt Ons..etc
Comment
-
Re: installing AEM UEGO Wideband Questions!
Yea because i Have the round firebird vents. I pulled out the big *** fire wall grommet and put the connector through that while it was out and then shoved it back in there.Originally posted by ACiFiC View Post
I forget if it was the F body or the W body that I had to trim the grommet a bit though.Comment
-
I am happy to announce that I have sold the site to Robert (FirebirdGT). Years ago this site went down when TealV6 had it, I bought it, refreshed it,...5 days ago -
Went ahead and moved my starter wire from the back, to the front again since it had no effect on my drain on the battery. Also made me nervous driving...3 weeks ago -
Building the Tom Henry RS
Part 4: Suspension Mods, Tires, Wheels, Headers and other Cool Stuff.
By: Hib Halverson
At the end of Part Three, we changed the valvetrain of the 3.8-liter V6 in the Tom Henry RS. We installed new, Yella Terra "Ultralite" 1.8:1, aluminum roller rocker arms, Katech valve springs and Katech titanium retainers on our 3800 Series II V6.
Ultralites are nearly 25% lighter than the stock 1.6 rockers and 8% lighter than the SLP aluminum...02-07-2020, 10:30 PM
Comment