Where to tap into slp cai for dry nitrous kit?

[runmy6]

I heard it is best to spray as far away from the maf sensor as possible, so can I drill into one of the two slp intake pipes or should i put the jet where the 2 pipes meet?

[12secondv6]

Dry nitrous kits... as far away from MAF.

You could drill and tap it all the way down by the air filters.... that would give the best cooling benifits of nitrous.

Get pic's please!!

[Loochy88]

would it be practical to drill a hole in the end of one of the filters itself? Zex actually makes a filter pre drilled like that.

[AllTheGoodNamesAreGone]

This is interesting.. i was wondering the same thing..

How bad is it if some of the nitrous gets on the filter? i am only concerened with safty..

[Loochy88]

i wonder if one of these filters would fit on the end of the slp cai


http://www.zex.com/information/produ...sairamplifier/

[AllTheGoodNamesAreGone]

sure.. as long as the inlet on the slp cold air is 2.5, 2.75, or 3.0 inches..

even if it isent you may be able to adapt it..

[Rick M.]

Both openings are 2.5"

[AllTheGoodNamesAreGone]

IT will work then..

[Loochy88]

maybe ill get one of those then. i wonder if theyre on ebay... (yes, im addicted)

[KillerBeeCamaro]

i was reading that zex site, they said that with that filter on no juice that it flowed more air then without the filter......how is this possible any restriction is a restriction right?

[AllTheGoodNamesAreGone]

[img]graemlins/bs.gif[/img] those people are fuggin' nuts

[Loochy88]

<blockquote>quote:</font><hr>Originally posted by KillerBeeCamaro:
i was reading that zex site, they said that with that filter on no juice that it flowed more air then without the filter......how is this possible any restriction is a restriction right?<hr></blockquote>

i believe the filter has a mini-electric-turbo-boat motor in it that can lift itself 6 inches off the ground under its own power. good for 20 or so hp [img]tongue.gif[/img]