Tweet
As many of you know...The Flowmaster system comes with the box looking resonator. Where should I install the cut-out...Before or After the resonator? Or I thought of replacing the resonator with the cut-out. What do you think?
-
-
Re: Where to install cut-out on Flowmaster system
i put mine after the resonator, if i did it again i would put it instead of the resonator though1997 Camaro LS1 RS
1994 Camaro - Sold
1999 Trans am Vert - Sold
A Few Mods.... -
Re: Where to install cut-out on Flowmaster system
do you have a sound clip and how did it make your flowmaster soundComment
-
Re: Where to install cut-out on Flowmaster system
yea check the sound clips post i posted last1997 Camaro LS1 RS
1994 Camaro - Sold
1999 Trans am Vert - Sold
A Few Mods....Comment
-
Re: Where to install cut-out on Flowmaster system
i highly recommend replacing the resonator with the cutout or just straight pipe. It'll make it sound 10 times better. Be aware it will be much louder too even with the cutout closedComment
-
Re: Where to install cut-out on Flowmaster system
what size cutout do you need if you replaced the resonator with the cutout?
Abbott long tubes,homemade true duals,slp ram air,whisper lid,eibach springs,kyb shocks,BMR subframe connectors, BMR LCA reloc brackets,BMR LCAs. T-top/manual convertedComment
-
Re: Where to install cut-out on Flowmaster system
2.5".. You might need a little extra piping too to fill in where the resonator was depending how long the main pipe on the cutout is.Comment
Comment