I was under the car the other day putting in a fuel filter and I noticed a couple things. 1, my torque arm bolts on the axle were finger loose. So I tightened those down. And 2, there's oil everywhere on the car around the pinion yoke. I was reading a thread about doing the pinion seal a few minutes ago and I have a few questions.
http://forum.camarov6.com/showthread...ht=pinion+seal
Do I need a new pinion nut after I remove mine? And what's up with the grease pencil, and rtv? Can't I just pull the yoke off, replace the seal, put the yoke back on, and torque the nut down to spec?
http://forum.camarov6.com/showthread...ht=pinion+seal
Do I need a new pinion nut after I remove mine? And what's up with the grease pencil, and rtv? Can't I just pull the yoke off, replace the seal, put the yoke back on, and torque the nut down to spec?
Comment