corvette servo

[mtscorvette]

hey i want to do the transgo shift kit and corvette servo combo. so i got the kit and the servo and am taking out the servo but its no fitting on the side, likes its too tight to get out/ does anyone have any tips for me? im assuming i have the drop the tranny a little bit? thanks!!!

[marvelrunner]

Re: corvette servo

Not sure if this helps but I saw this on youtube a while back.

http://www.youtube.com/watch?v=4WpjGQnEixo

[bigbrian442]

Re: corvette servo

Try leaving the pin in place and changing the servo by removing the E clip from the pin with the pin still in the trans.

[mtscorvette]

Re: corvette servo

thanks, I actually watched that right before I went to do it haha, the thing is , its hitting the floorboards, so it looks like im just gonna have to drop the back a little bit, but thanks!

[mtscorvette]

Re: corvette servo

Try leaving the pin in place and changing the servo by removing the E clip from the pin with the pin still in the trans.

ill give it a try but i dont know if it will fit, its like if i pull the cap straight out but it catches the 4th apply piston and if i tilt it a little bit one of the ends goes back into the housing a little bit. ill give it a shot though, thanks!