1.9 rockers, Audio stuff, Hypertech, and Jet Chip - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

1.9 rockers, Audio stuff, Hypertech, and Jet Chip

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

    I have some stuff I want to get rid of, and I thought I'd help you out by selling it, and you'd help me out by buying it. ;)
    I used all parts and can verify they work great.
    FYI- I'm extremely open to trades, so don't be shy- just ask.
    Paypal preferred, but money orders and personal checks also accepted.

    MACE Engineering 1.9 Ratio Rockers and guideplates. SOLD
    -Bought from this group: 1.9 rocker group
    -New, Never installed
    -These will work on any 3800II engine, L36 & L67.



    Hypertech Power Programmer III. Goes for $340 online - SOLD
    -2000-2002 V6 Camaro (Auto or Manual)
    -2000-2002 V6 Firebird (Auto or Manual)
    -Regular and Premium fuel tunes
    -Adjust Shift Points and firmness (auto only)
    -Adjust Rev Limiter
    -Correct Speedo for Gearing changes
    -Correct Speedo for tire size changes
    -Reads, displays, and clears DTC's
    -Change top end limiter
    -Change fan switch temps
    -Easy to yes "yes" and "no" interface. Plug into OBDII Port, answer a few questions, and you're good to go.

    LINK

    Jet Chip Stage II #10119S. Goes for $330 online - SOLD
    -2000-2002 V6 Camaro (Auto only)
    -2000-2002 V6 Firebird (Auto only)
    -Installation is just a socket and a screwdriver away: pull PCM screw with a 7mm (I Think) socket, plug in chip, tighten screw with a flat-head screwdriver, and re-screw PCM.
    -The only thing "wrong" with the chip is the plastic that holds the pins is milky and has a few spider cracks, presumably from over-tightening. It still works great and the cracked plastic is protected from the weather, where it won't be a problem.

    Subthump.com Driver's side 10" charcoal Sub box. Goes for $112 online - $100 Shipped to lower 48
    -fits any '93-'02 F-Body
    -.6 Ft^3

    Subthump.com Amp Rack, Charcoal. goes for $68 online. - SOLD
    -fits any '93-'02 F-Body

    Rockford Fosgate 10" Punch HX2 model RFD2210- $100 Shipped to lower 48

    -Used with the subthump box.
    -Recommended sealed box volume -.2-.75 Ft^3
    -Dual 4 Ohm voice coils
    -Santoprene Surround
    -LX Cast Basket
    -Hyper extend aero-vent pole
    -3.0" Voice Coil
    -500 Watts RMS, 1000 Watts Peak
    -.55" XMax

    I wired this up with my amp at 8 Ohms, 480 Watts RMS and it sounded awesome.

    Rockford Fosgate 800.2 Amp - $150 Shipped to lower 48
    -Factory refurbished
    -2 Channel
    -960W MONO @ 4 Ohms
    -480 W x2 @ 2 Ohms
    -240 W x2 @ 4 Ohms

    The only thing "wrong" with it is one of the holes for mounting the end caps is stripped. 2 minutes with a die and a slightly larger screw (or just a dab of superglue) and it's good as new. I just want to be honest with you guys, so you know exactly what you're getting.

    I'll sell the audio stuff as a package - everything you need to wire this stuff up(except a head unit), including amp rack, sub box, sub, amp, wiring, and mounting stuff for $300 shipped.


    Last edited by Inferno; 03-11-2009, 08:26 PM.

  • #2
    Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

    Pictures of the sub box.
    sigpic

    Comment


    • #3
      Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

      pm sent

      Comment


      • #4
        Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

        need a computer i will trade you a computer for your rockers lol
        2001 Camaro 3.8 A4
        1991 3000GT VR4
        2001 Mitsubishi Eclipse GS

        Comment


        • #5
          Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

          Originally posted by bigbrian442 View Post
          Pictures of the sub box.
          Pix later today. It's effin cold and was too dark to snap a pic before school.

          Originally posted by tomham View Post
          pm sent
          PM Replied

          Originally posted by vr4gasm View Post
          need a computer i will trade you a computer for your rockers lol
          Specs on computer?

          Comment


          • #6
            Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

            i got a 3800 stall convertor from tci for an lt1 i will trade you for the rockers
            96 camaro auto base model<br />slp cai<br />pacesetter headers<br />flowmaster catback<br />35th anniversary ss wheels<br />richmond 3.73<br />98+ ss spoiler<br />hypertech 160 degree thermostat<br />transgo shift kit

            Comment


            • #7
              Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

              pm sent
              2001 Camaro 3.8 A4
              1991 3000GT VR4
              2001 Mitsubishi Eclipse GS

              Comment


              • #8
                Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                Originally posted by David8399 View Post
                i got a 3800 stall convertor from tci for an lt1 i will trade you for the rockers
                Sorry, I don't own an LT1 or i'd be all over that. Got anything else?

                Comment


                • #9
                  Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                  i have a turbo i will trade you lol
                  2001 Camaro 3.8 A4
                  1991 3000GT VR4
                  2001 Mitsubishi Eclipse GS

                  Comment


                  • #10
                    Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                    Sorry, but I'm sticking with superchargers... for now :)

                    Comment


                    • #11
                      Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                      supercharge AND turbo ;D
                      2001 Camaro 3.8 A4
                      1991 3000GT VR4
                      2001 Mitsubishi Eclipse GS

                      Comment


                      • #12
                        Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                        Haha If you can tune it, we'll do it.
                        And I was wrong. Amp is an 800.2. Original post edited to reflect that.
                        More pix!!!





                        Last edited by Inferno; 03-04-2009, 04:00 PM.

                        Comment


                        • #13
                          Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                          hey man I'll take that amp rack off your hands email me paypal info, bdu1234@yahoo.com
                          -Brad
                          98 Firebird - gone from mod mode to keep it running and useable mode.
                          2000 V-Star Custom 1100
                          If all else fails use a bigger hammer!
                          :rock:

                          Comment


                          • #14
                            Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                            how did you like the hppIII? i plan on using hptuners down the road and doing everything with that, but i'm about to change my rims and tires and want to recalibrate for that, and adjust my fan temps for my 180* and some other stuff i've recently done. i know there's no big gains to be had behind the programmer, but would it be worth getting just to change a few settings until i get a dynotune down the road?
                            pacesetters|full 3" borla exhaust|3" stainless e-cutout|slp cai & ram intake|c/f whisper lid|tbs|eibach|kyb|stb|sfc's|adj.lca's & phb|slp fan|b&m t5|180*|z06 17x9.5|8000k hids|hptuners|d/s rotors


                            sigpic
                            gone in body, but not in spirit

                            Comment


                            • #15
                              Re: 1.9 rockers, Audio stuff, Hypertech, and Jet Chip

                              Originally posted by BallerMaro13 View Post
                              how did you like the hppIII? i plan on using hptuners down the road and doing everything with that, but i'm about to change my rims and tires and want to recalibrate for that, and adjust my fan temps for my 180* and some other stuff i've recently done. i know there's no big gains to be had behind the programmer, but would it be worth getting just to change a few settings until i get a dynotune down the road?
                              That depends on your definition of "worth it."
                              It would bug the hell outta me if my speedo was off all the time, so yes, it's "worth it" to me. Also, if you have mods that it lets you tune for, that's just another reason to have one. And compared to a $300 dyno tune or $5-600 for HPTuners, i'd say it's a cheap step in the right direction til you can get a true "tuner." This is just my opinion, of course. The real decision is up to you.

                              Comment

                              Latest Topics

                              Collapse

                              There are no results that meet this criteria.

                              FORUM SPONSORS

                              Collapse
                              Working...
                              X